Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Install & Configure jDiction / Re: Help needed - Translating doesn't work properly

« on: March 16, 2015, 03:04:52 pm »

I made it!!! )

Finally it works for me! Thank you very much for the great plugin!

2

Install & Configure jDiction / Re: Help needed - Translating doesn't work properly

« on: March 12, 2015, 07:13:57 pm »

The language is everywhere "All". Is it possible for you to log in directly ? i am online for the next two hours

I managed to get all greens: http://prntscr.com/6fxa81

However, the situation is still the same

3

Install & Configure jDiction / Re: Help needed - Translating doesn't work properly

« on: March 12, 2015, 09:13:44 am »

Sry, i could not reply sooner. I am using a template created with Artisteer tool. However, the problem exists even if i switch to standard preinstalled template as well.

Sending you the link via pm now.

4

Install & Configure jDiction / Re: Help needed - Translating doesn't work properly

« on: March 10, 2015, 06:04:42 pm »

Thank you.

Here is the result of the check page: http://prntscr.com/6f3on0

From what i read in forum, i understand that the plugin has to be the first one to be loaded. However, when i am moving it upwards (as guided in installing instruction). I cannot move it higher than some other positions. I tried changing templates to joomla preinstalled, doesn't work.

5

Install & Configure jDiction / Re: Help needed - Translating doesn't work properly

« on: March 10, 2015, 05:12:02 pm »

Could you please guide me how to do this? I am a bit new to web administration. Thank you!

I read the forum through earlier today, but could not really find an answer how to find the check page

Under components menu there is no jdiction sub-menu

6

Install & Configure jDiction / Help needed - Translating doesn't work properly

« on: March 10, 2015, 05:09:22 pm »

Hello and thank you for producing this great plugin.

Unfortunately, i could not make it work properly in my case. I am facing the following issue:

once i press the flag for a different language, its only one article which is being translated. To be exact: i can access the whole website in english, that works good. I can see language flag everywhere. When i press it, it translates the single article opened in this very moment. All menus disappear.

Your help is very much appreciated.